모델명 : ETCR6200

원산지 : CHINA

브랜드 : ETCR

Ⅰ. Introduction

ETCR6200 AC/DC Leakage Current Clamp Meter also named: Car Leakage Current Clamp Meter, Car Standby Current Clamp Meter, Car Inrush current Tester, Car Charge Current Tester. It is specially designed for online measurement of AC/DC leakage current, current below 600V by adopting up-to-date CT technology and digital integration technology. It is especially suitable for measure car standby current, leakage current, inrush current. It is a product with the characteristic of relatively small size, high accuracy, strong anti-interference capability and automatic shifting. It is apply to car leakage rapid detection, consumed current detection, quickly find the fault of the wire broke leakage, equipment fled electric, line contact with iron, measuring the motor inrush current and alternator charge current etc. It could be widely use in those fields as car repair, car leave factory test, car parts test, the current detection in telecommunication room, electric power overhauling, meteorology, oil detection, etc.

It has those functions as peak holding, data holding and data storage. It obtains one RS232 interface, communication cable and software, through the computer, it can online real-time monitoring, historical query, dynamic display, MIN-AVG-MAX indication, alarm setting and indicating, data reading, saving and printing.

Ⅱ. Technical Specification

Model

ETCR6200

Function

Measurement of AC/DC current, leakage current, repairing the car circuit.

Power Supply

Zn-Mn dry battery,6F22,9V, continuous use for 30h

Test Mode

Clip-on CT, noncontact measurement

Clamp Size

25mmX35mm

Measurement Range

0mA~60.0A AC/DC

Resolution

1mA AC/DC

Accuracy

±2%rdg±5dgt (23℃±5℃, below 75%rh)

Display Mode

Four digits LCD display

Dimension

LWH: 168mm×65mm×34mm

LCD Dimension

35mm×21.5mm; display domain: 32mm×15mm

Sampling Rate

2 times/s

Frequency

AC: 45Hz-400Hz

Polarity Indication

DC current auto identified and display“—”

Test Position

Tested wire in the jaw center

Range Shift

Automatically

Line Voltage

Do not exceed AC 600V

RS232 Interface

Data stored in the memory of the meter via RS232 upload to PC

Com-Configure

Baud rate:9600, data bit:8, stop bit:1, check bit: NONE

Data Memory

99 units, FULL blinks when the memory is full

Reading Hold

DH indicating the reading is hold

Out of Range

OL indicating the current is out of range

Auto Power-off

5 Minutes after power on, it will power off automatically to lower the power consumption

Battery Voltage

    Indicating the battery voltage is lower than 7.2V.Then the battery have to be changed.

Weight

180g (including the battery)

Working Current

10mA

Humiture

-10℃-50℃,below 80%rh

Limit Temperature Error

-10℃-0℃ and 40℃-50℃, within 2%rdg

Humiture Storage

-10℃-60℃,below 70%rh

Insulating Strength

AC 3700V/rms. (between the alloy of the clamp and the housing)

Applicable safety rules

IEC1010-1, IEC1010-2-032, pollution:2, CAT Ⅲ(600V)

Accessories

Meter: 1pc; toolkit: 1pc; RS232 communication line: 1pc; disk: 1pc; case: 1pc.